Ellis - Drill Press - 9400

Features:
• Variable speed from 0 to 1200 rpm
• Adjust speeds while operating in the material
• High torque at low rpm speeds
• Instantaneous reversing for tapping
• Tapping head is not needed
• Machine tap goes into ball bearing chuck
• Can tap either left or right handed threads
• Drill head and table rotate 360° around column
• Smooth operating table raiser
• Fully enclosed spindle
• Quill lock and depth control
• Same ball bearing chuck holds both drill and tap

Speed Control:
• Continuous speed adjustment while in operation
• Instantaneous reversing for tapping
• One turn on knob for adjusting speed (0 to 1200 rpm)

Motor: 2 HP A.C. single phase - choose 110/220

Spindle Speeds: 0 - 1200 RPM

Drills to Center: 18 1/8 in.

Drilling Capacity: steel 1 1/16 in., cast iron 1 1/4 in.

Tapping Capacity: 3/4 in.

Morse Taper: No. 3

Quill Diameter: 3 in.

Column Diameter: 4 in.

Spindle Travel: 5 3/8 in.

Spindle to Table (max): 27 1/4 in.

Spindle to Base: 46 1/4 in.

Shipping Weight: 675 lbs.

Table Production Type: t-slotted 15 7/8 in. x 17 7/8 in., 2 slots for 1/2 in. t-bolts, ground working sufrace, coolant trough

Base: t-slotted, 16 3/8 in. x 26 5/8 in., 2 slots for 1/2 in. t-bolts, ground working surface

Size: height 69 1/2 in., width 20 in., depth 29 in.

Optios: power down feed, ball bearing chuck, drill press vise, round table (Please contact with inquires)

Case Pack: 1
UOM: Each

Check out these specials! Get a chuck for $125.00 or a vise for $250.00!

Top of Page ^